![]() You are receiving this because you were mentioned. Then watch your fans IRL as you slide each to figure out which is which. ![]() Just assign a curve to the appropriate control, it should work. Install the build requirements (tested in Ubuntu 18.04): sudo apt update sudo apt. Furthermore it communicates with systemd via dbus to control the fancontrol service. It uses the KAuth module of the KDE Frameworks 5 to write the generated config file. On Jun 3, 2022, at 12:41 PM, Rem0o wrote:īut you mentioned the fans stopped during detection right? Don't bother with the speed cards with RPM, or any of the "detected" stuff from the assisted setup. fancontrol-gui is a GUI for fancontrol which is part of lmsensors. 4, 5 and 6 run off a different chip, not the main chipset. Ive seen a few times where default settings clears up stuck bios issues. You are receiving this because you were mentioned.Message ID: from my iPhone One thing to do is save bios settings, clear CMOs and once back in, set default setting, save & exit and upon reboot, enter bios and change you settings or load save bios settings. If you can see your fans changing speed, then you're all good. On Jun 3, 2022, at 7:20 AM, Rem0o That's because since you got multiple fans on the same channel, the RPM detection is bust, so it can't rely on it. You are receiving this because you authored the thread.Message ID: from my iPhone Reply to this email directly, view it on GitHub, or unsubscribe. ![]() And is the Mobo Controller set to the Right DC or PWM Control on SYS_Fan 1 corresponding to your Fans Ans what Connection do ther Use 3 Pin DC Control or 4 Pin Pwm Control. On Jun 3, 2022, at 7:13 AM, Audipower wrote:Ĭan you Control this Fans with the Mobo Settings in Bios ? Some Case fans are 1 Speed Only. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |